KeratinPerfect 30 Day Brazilian Hair Smoothing System How To
The KeratinPerfect 30 Day Brazilian Hair Smoothing System will give you salon quality keratin treatments in the comfort of your home and it will last 30 days! The special blend of keratin proteins and the new ReBonding technology forms a protective layer to help seal in moisture and shine.
Before You Begin The Treatement
Remember before you begin the treatment have all of these items available
- Hair Clips
- Hair Dryer
- Flat Iron that reaches 430 - 450 degrees F
Step 1: ShampooStart with KeratinPerfect Clarifying Shampoo
Shampoo hair with a quarter sized amount of the KeratinPerfect PerfectPrep Pre-Treatment Clarifying Shampoo then rinse - do not completely rinse between each wash allow a little bit of the shampoo to remain. If you have non-chemically treated hair wash hair 3 times. All other hair types wash hair 2 times. Rinse hair completely after the final shampoo. Do not use conditioner.
Tip: Only use the KeratinPerfect Clarifying shampoo for this step, all others may hinder the performance of the treatment.
Step 2: Towel Dry Hair
Towel Dry and Detangle Your Hair
After shampooing is complete towel dry hair. Assure the hair is damp not dripping wet. Comb and detangle hair completely. Your hair should feel squeaky clean which means your hair is completely clarified and ready for the treatment.
Clarifying the hair helps to open up the cuticles in your hair shafts and better allows the keratin to bond with your hair.
Step 3: Apply the Treatment
Apply the KeratinPerfect 30 Day Hair Smoothing Treatment
Shake the KeratinPerfect ThePerfector 30-Day Hair Smoothing Treatment tube. Pump product onto hair or pour into measuring cup. Use varying amounts for differing hair lengths as shown below. Measuring cup is included.
Short, Chin Length Hair: 1- 1.5 oz.
Shoulder Length Hair: 1.5 - 2 oz.
Very Long Hair or Coarse Hair: 2 - 2.5 oz
Part hair down the middle of the hair and separate hair into 4 separate sections. Leave one section down preferably the section in near the back of the neck and put the other sections up securing with a clip. Apply treatment directly onto 2 inch sections. Comb the treatment into each section to evenly distribute the treatment.
Repeat for each section. After the treatment is applied to the enter head, comb through your hair for 3 minutes. Comb away from face. Assure that the treatment is applied to the back of the head. Do not rinse the treatment. Keep treatment in hair for 10 minutes. Remove any excess product with the comb provided.
Step 4: Time to Blow-Dry
Please remember do not rinse treatment. After leaving treatment in hair for 10 minutes, blow dry your hair until it is completely dry.
Step 5: Sealing the Keratin
Use a Flat Iron to Seal the Treatment
The flat ironing step will allow the keratin to infuse in your hair and close the cuticle, leaving your hair smooth and shiny. Use the guide below to set your flat iron at the correct temperature:
- 380º F - 410º F | 3 Passes: Damaged, Double Processed, Bleached, Gray, or Fine Hair; Full Highlights
- 410º F - 430º F | 5 Passes: Color Treated or Chemically Processed Hair; Partial Highlights
- 430º F - 450º F | 7 - 10 Passes: Coarse, Resistant or Virgin Hair (Hair that has not been colored or chemically treated)
Part hair down the middle and seperate into 4 sections, leaving one section down, preferable the one at the back of your neck. Start with the section that is down and flat iron 1 to 2 inch sections of hair carefully. To prevent burning your hair do not allow the iron to stop on one area. Pass over each section 3 to 10 times wit the flat iron depending upon your hair type as shown above. Hold each piece away from your face an lead with the comb as you pass the flat iron through your hair. Use the comb as a guide and to help control each section. Continue with the remaining sections.
Step 6: Post Treatment
The treatment should stay in your hair for 48 hours. Do not shampoo or get your hair wet during this period. If your hair does get wet blow dry and flat iron immediately. The waiting period allows the keratin to fully bondy wo the cuticle so you get the smoothest result.
During the waiting period do not put anything in your hair that will leave an impression including tight clips, sunglasses, and ponytail holders. If necessary, use a silk scarf to hold your hair back instead. Do not use styling products during the waiting period.
After the waiting period, shampoo and condition hair with the KeratinPerfect PerfectCleanse Keratin Enhanced Shampoo & the KeratinPerfect Perfect Silk Keratin Enhanced Conditioner. To protect and prolong the results it is important to use this color safe, sodium chloride free and sulfate-free shampoo and conditioner. Other products will strip the effects of the keratin. Wash hair as infrequently as possible to further extend the treatment's results.